Ethernet configuration, Login configuration, Web configuration – 2N VoiceBlue MAX v1.4 User Manual
Page 60
60
missed calls.
Ethernet Configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in
.
2N VoiceBlue
®
MAX
IP address – the fixed IP address (v4) of the
Ethernet
2N VoiceBlue
®
MAX
interface.
Subnet mask – the subnet mask for the
Ethernet
2N VoiceBlue
®
MAX
interface.
Default gateway – The IP gateway IP address (v4) in the Ethernet network.
– primary DNS server.
DNS server1
– secondary DNS server. Used as a back-up when DNS server 1 is
DNS server2
not functional.
Login Configuration
The window helps you set the access password and name for the 2N VoiceBlue
®
MAX
web interface. Use the same data for Telnet connection too.
Web Configuration
Set additional parameters for the gateway web interface.
Auto logout – set the count of minutes in which the current user should be logged
out automatically.
Enable web session lock – by default, one Admin user may only be connected to
Note
You are recommended to read the Mobility Extension section on page
carefully before using the Mobility Extension function.
Caution
Incorrect settings, e.g. enabling the
service, may result in a
DHCP client
denial of access to the
configuration. To avoid this,
2N VoiceBlue
®
MAX
restore the GSM gateway default settings. Refer to
for details.
Tip
In case the gateway is in the DHCP client mode, current assignments
obtained from the DHCP server are displayed in the
,
IP address Subnet
and
items.
mask
Default gateway
Caution
Remember to
the username and password
the first
change
during
gateway configuration to avoid unauthorised access!