Lcr table – 2N VoiceBlue Next v3.7 User Manual
Page 58
58
Table of replaced prefixes
This table helps you change the prefix of the number received (from 00 to +, e.g.). You
can just add or remove a prefix using this table. This change is performed before the
prefix table search is initiated. Keep the „"/ „" record at least in the table for a proper
function.
Table of accepted prefixes
A list of prefixes of called destinations to which the selected prefix list applies.
LCR table
The LCR (Least Cost Routing) table helps route calls according to the called number
and depending on the day time and weekday.
Prefix list – select a list of prefixes to be used for the selected LCR row.
Time limitation – set a time limitation for a particular LCR row.
Weekend usage – enable/disable a particular PCR row during weekends.
Maximum call length – set the maximum length (in minutes) for an active
outgoing call to GSM/UMTS.
Groups – set the GSM outgoing groups to be used for the selected LCR row.
Tariffs – select the tariff group (free minute counter) to be used for the outgoing
call. Refer to the
for more details.
GSM outgoing groups
Ignore tone detection in last group – having detected a user defined tone (refer
to
), the GSM gateway terminates the call and seeks for
GSM basic settings
another call setup option by default. If this parameter is activated, the GSM
gateway ignores the tone detection results and sets up the call if this is the last
call setup option.
Note
The number to be dialled to the GSM/UMTS network must meet the
condition.
Count of digits
For
calls, the count of digits to be dialled must be equal to or higher
VoIP
than the value set in the
.
Count of digits
Note
The maximum count of records in the
is 14
Table of replaced prefixes
for each prefixlist.
The maximum table record size is 9 characters for the prefix and 9
characters for the replaced number.
Note
The maximum count of records in the
is 138
Table of accepted prefixes
for each prefixlist.
The maximum table record size is 9 characters.