Prefixes – 2N BRI Lite/Enterprise v1.8 User Manual

Page 71

Send CLIP from GSM/UMTS to VoIP

Transfer CLIP from GSM/UMTS – enable/disable the function.
Separating char – set the separator for the SIM card CLIP and ID of the
extension to be called.
Modify – modify the extension ID.

Others

Time to keep CLIP in table – set the record keeping time for AutoCLIP routing.
Add record only for unconnected call – enable storing of unconnected outgoing
calls in the AutoCLIP table only.
Delete record for connected answer – enable deletion of an AutoCLIP record in
the case of successful CallBack.
Skip DTMF for numbers not in CLIP Routing table – enable this option to set
DTMF to the incoming calls only whose CLIP is included in the CLIP Routing table.
Skip list of called numbers after failed call to wanted number – enable this
function to disable forwarding of incoming calls to the numbers included in the

if rejected after DTMF.

List of called numbers
Auto end to CallBack request – enable that the incoming call whose CLIP meets
the CallBack settings will be rejected. If not, the call will be ignored. The CallBack
function will be retrieved after call end in both the cases.

List of called numbers

List of numbers to be dialled if DTMF dial–in was not made. Search the table from top
to bottom. If the called user is inaccessible, use the following table record

Prefixes

Use this window to adapt the gateway to calling to various GSM providers' networks.
Set the call routing rules based on prefixes for up to eight groups.

Prefix list 1–8

Eight prefix groups to be assigned in the LCR table.

Basic settings

GSM network ID – set the prefix list user code for easier orientation in the LCR.
Default count of digits – default length of the number to be dialled into the
GSM/UMTS networks for routing via the selected prefix list. Use this parameter in
case the

is not included in the

table.

Digits count

Accepted prefixes

Caution

The

service must be supported by the

Send CLIP from VoIP to GSM

GSM/UMTS provider's network. Otherwise, the call may be rejected by
GSM/UMTS.