2N BRI Lite/Enterprise v1.8 User Manual

Page 67

Generate virtual ring tone – enable/disable generation of the virtual ringing tone
into the VoIP interface.
Call length counting – define whether call minutes or seconds shall be counted.
After call relax delay – set the time between the end of the current call and start
of the next call via one and the same GSM/UMTS module. The recommended
value for heavy–traffic installations is 2 seconds!

Add random time – use this auxiliary parameter to add random time in
seconds. Thus, the resultant time is the sum of the two above mentioned
parameters.

Network settings

BTS lock – identify the BTS to which the GSM modules shall log in. Restart the
selected GSM modules to execute the changes.

Network operator code (MCC+MNC) – set the local mobile network provider code
manually. If you do not enter a value, the provider will be selected automatically.
Network register attempts – set the count of network registration attempts if the
network rejects to register the +CREG:3 SIM responses.
Network register delay (0-3600)[s] – set the registration delay, i.e. the timeout
within which the network may send another response after rejecting +CREG:3.
Enable USIM and SIM Application Toolkit – enable/disable the USIM and SIM
Application Toolkit services for the Telit HE/GE 910 modules.

Disconnect Call

Set the rules for automatic disconnection of outgoing calls to a wireless network.

SIM limit exceeded – automatic call disconnection when the active SIM card call
limit is exceeded.
Time limit exceeded – automatic call disconnection when the active SIM card
time of use is exhausted.
No ALERTING before CONNECT – automatic call disconnection when the gateway
receives the call connect message without alerting.

Send CLIP from VoIP to GSM/UMTS

Transfer CLIP to GSM/UMTS – enable/disable the function.
Separating char – define the CDN/CLIP separating character.
Modify (‘–’ remove one digit) – change the CLIP. The ‘–’ character is used for
deleting one character from the left.

Caution

The BTS lock service work with specific GSM modules only (Q55, Q24,
GE910, HE910)!
If you set a wrong BTS lock, the selected GSM module(s) will not log in to
GSM.

Caution

The

service must be supported by the

Send CLIP from VoIP to GSM

GSM/UMTS provider's network. Otherwise, the call may be rejected by
GSM/UMTS!