5 log files – 2N BRI Lite/Enterprise v1.8 User Manual
Page 112
112
6.5 LOG Files
Description of the table:
Type
Text
Description
POWER
[Power on]
System switched on
[Power off]
System switched off
[Warm boot]
Restart of system, unknown cause
[Watchdog]
Restart of system by watchdog
[BKPT code]
CPU error: break code detected
[Stack error]
CPU error: stock integrity failure
[Divided by
zero]
CPU error: dividing by zero
[RETI code]
CPU error: illegal using of instruction reti
[NMI intr]
CPU error: wrong interrupt
[VOID intr]
CPU error: wrong interrupt
[Upgrade reset] Start of upgrade firmware procedure
[Software
reset]
Reset by AT commands (at&fres…)
INIT
Eeprom
Initialisation of eeprom (configuration)
Flash
Initialization of flash memory (firmware)
HW–ERR
(##…address of chip, RD…read value/WR…expected
value)
Duart
#####,RD/WR
Error in initialization of serial controller on GSM board
SYSERR
User stack
error!
SW error: stock integrity failure
BRDIN
#08 TYP STS
the board inserted (number of gsm board, type, status)
BRDOUT #08 TYP STS
the board disconnected
BRDRES
#08 TYP STS
Reset the board by AT command
ALL GSM
RESET CMD
Reset of all GSM boards by AT command
SYSTEM RESET
CMD
Reset of system by command at&bsys
L1–ERR
(reserved)
L2–ERR
Error of 2. ISDN layer by Q.921
A: unsol.RX(F)
Received packed RR,RNR,REJ with unexpected bit F=1
B: unsol.DM(F)
Received packed DM with unexpected bit F=1
C: unsol.UA(F)
Received packed UA with unexpected bit F=1
D: unsol.UA(–)
Received packed UA with unexpected bit F=0
E: unsol.DM(–)
Received packed DM with unexpected bit F=0
F: peer re–est
Received packed SABME in status OKEST
G: repeated
SABME
Repeated unsuccessful send of packet SABME