Licence limitations, Poe supply connection, Firmware upgrade – 2N Indoor Touch User guide v1.2 User Manual
Page 14
14
1.
2.
Use any 12V/2A DC power adapter connected to the terminal board (see the
figure).
Use an Ethernet cable connected to a PoE supply or PoE supporting Ethernet
switch/router.
A successful operation is indicated by a status RGB LED or LCD display.
PoE Supply Connection
Use a standard straight RJ-45 terminated cable to connect
to the
2N
Indoor Touch
®
Ethernet. The device supports the 10BaseT and 100BaseT protocols. The Ethernet
connection state is indicated by the LEDs placed on the RJ–45 connector.
Refer to
for the factory settings of the
2N
Indoor Touch
®
Ethernet interface.
Licence Limitations
2N
Indoor Touch
®
can contain time-limited software licences. Refer to
Firmware Upgrade
We recommend you to upgrade the
firmware during installation.
2N
Indoor Touch
®
Refer to
for the latest FW version. Refer to
for the
firmware upgrade procedure.
Caution
Factory reset results in a change of the Ethernet interface configuration!
A defective Ethernet cable may lead to a high packet loss in the Ethernet
and subsequent instability and poor video call quality!
Warning
Connection of a defective or improper power adapter may lead to a
temporary or permanent failure of the 2N
Indoor Touch
®
unit!