2N Omega series - Configuration Tool manual v1.10 - Manual (Page 26)

26
2.1.14. Voices
Here you can change the voice settings (system, user and music to make
waiting more pleasant).
System voices
The PBX contains 11 systems voices. The voices notify the user about being
redirected, accepting the service dialled, a more expensive call in the LCR (least
cost routing) etc...
In this cat
egory there is also “music to make waiting more pleasant –
MusicOnHold“.
It is not recommended to make changes to the system voices.
User voices
They are for notifying the caller in DISA.
After reading the DAT from the PBX this table will display a list of the voices
contained in the PBX.
Pressing the key “Load“ saves the voices in the “Wav“ directory, which are
then automatically formed in the root directory of the installed PBX‟s configuration
tool.
If you are going to make changes in the voices settings it is necessary to first
put the voice in this “Wav” directory and then set it here. A voice is a type of wav
and must have the following parameters: MONO - 8bit - 8kHz - unsigned.
The overall capacity of the voices is ca. 3 minutes. The length of the system
voices including the music is ca. 40 sec.