Echo 76824 Owners Manual v.1 - Manual (Page 11)

PN 18280-00 R121505 9
Section
Assembly
2.1 TIRES AND RIMS
2.2 TRAILER HITCH
2.3 CHIPPER CHUTE
Mount the chipper chute to the hydraulic feed using eight 3/8" x
1" bolts and locknuts. To insert the top bolts, you may need to
temporarily lift the grab roller with a pry bar. Use three bolts on
each side and two on the bottom (Figure 2.1).
Do not operate this unit without the chipper chute correctly
installed. Rotating cutting blades can cause serious personal
injury.
WARNING
2
Before inspecting or servicing any part of this machine,
shut off power source, disconnect the hydraulics, remove
ignition key and make sure all moving parts have come to
a complete stop.
WARNING
If any bolts or nuts are dropped in the machine, be sure to
remove them before starting the machine. Remove items
from the shredder area by removing the discharge screen.
IMPORTANT
Mount tires and rims to the axle using the lug nuts (in owner's
kit).
Attach the fender supports to the trailer using three 1/2" x
3-1/2" Hex bolts, washers & nuts.
1.
2.
Attach the fenders to the fender supports using four 3/8" x 1"
carriage bolts, washers and nuts.
3.
Slide the hitch into the trailer frame and secure using two 1/2" x 4-1/2" hex bolts, washers and nuts (provided in owner's kit). 1.
Figure 2.1 - Chipper Chute Assembly
CHIPPER CHUTE
HYDRAULIC FEED