beautypg.com

Warning – Echo 76824 Owners Manual v.2 User Manual

Page 32

background image

PN 18280-00 R041306

30

SERVICE & MAINTENANCE

BEFORE INSPECTING OR SERvICING ANY PART OF ThIS MAChINE, ShuT OFF POWER SOuRCE,

DISENGAGE ThE hYDRAuLICS, OPEN ShIELD AND MAkE SuRE ALL MOvING PARTS hAvE COME TO A COMPLETE STOP.

WARNINg

Mounted bearings are pre-lubricated at our factory and are

ready for operation.
LubRIcATIoN
Lubrication of bearings is determined by operating conditions

and environment. Lubricate standard bearings with a LIThIuM

based grease. Greasing intervals are shown on the next page

using the following symbol:

Frequency (50 hours)

gREAsINg INTERvALs
Bearings in extreme environments will require more frequent

greasing intervals.

gREAsE fILL AMouNTs
It is preferred that experience dictate fill amounts due to wide

variances in applications, greasing equipment and operat-

ing conditions. In most cases, it is best to lubricate in small

amounts, under low pressure, until a thin bead of fresh grease

is visible at the seal lip area.

5.10 gREAsINg

Care should be taken when greasing bearings to avoid overfill-

ing. Overfilling can lead to excessive heat and/or unseating of

the seals Grease should be introduced in small amounts and

under light pressure. Whenever possible, the bearing should be

rotated slowly while grease is added to ensure equal distribution

throughout the raceways.
The chipper models described in this manual have several

bearings that require greasing. Refer to the figures on the next

page for greasing locations and intervals.

The use of pneumatic grease equipment is not recommend-

ed unless low pressure is assured.

WARNINg

Polyuria and lithium based greases are not compatible. Mix-

ing the two grease types may lead to premature failure of

the chipper.

WARNINg

This manual is related to the following products: