Echo 76824 Owners Manual v.2 - Manual (Page 26)

PN 18280-00 R041306 24
SERVICE & MAINTENANCE
BEFORE INSPECTING OR SERvICING ANY PART OF ThIS MAChINE, ShuT OFF POWER SOuRCE,
DISENGAGE ThE hYDRAuLICS, OPEN ShIELD AND MAkE SuRE ALL MOvING PARTS hAvE COME TO A COMPLETE STOP.
WARNINg
Refer to the engine owner's manuals included with your machine for specific instructions on replacing and cleaning the air filter.
5.4 AIR fILTER
Check wheel bolt torque every 8 hours of towing.
Check air pressure in tires every 8 hours of towing. Inflate
to pressure marked on sidewall of tire.
1.
2.
5.6 TRAILER
Check and repack wheel bearings with grease every 12
months.
When towing, use a the proper size trailer ball, and always
connect the safety chains. Make sure trailer hitch bolts are
tight and secure.
3.
4.
5.5 pLuggED DIsk
If the machine becomes plugged, lift the engagement handle,
shut off the engine, disconnect the spark plug wire and al-
low the machine to come to a complete stop before clearing
debris. Do not operate the machine without proper guards
and shields in place.
WARNINg
Feeding too large or too much material at once may plug the
chipper. To clear a plugged disk, proceed as follows:
Lift the engagement handle and turn off engine key switch.
Remove the two 3/8" retaining bolts holding the access cover
to the chipper frame and lift up access cover.
Clean the debris away from the chipper disk. Turn the disk
by hand to be sure it is free to rotate. Be careful to avoid the
chipper blades when cleaning out the debris.
Close access cover and replace bolts.
Start the engine. Lower the engagement handle when en-
gine is running to engage drive belt. Resume operation at
1/4 throttle.
1.
2.
3.
4.
5.