beautypg.com

3 hydraulic feed maintenance, 4 safety bar (72854s) – Echo 71854 User Manual

Page 16

background image

PTO CHIPPERS

14

HYDRAULIC FEED

4.4 saFeTY bar (72854s)

4.4.1 reseTTing THe cHiPPer
The safety bar located along the chute extension tray will

stop the chipper when pushed in. The reset button for this

bar sits on top of the chipper chute. When the safety bar

has been activated, a red light will come on signaling that

the operator reset button will need to be pushed before the

feed roller will function. if false trips occur, the reset button

can be held in to override the system. upon start-up, the

safety bar light will be on and will need to be reset before

the feed roller will operate.
4.4.2 locking in Travel PosiTion
The safety bar will lock into travel position. Place the

extension tray in an upright position. Pushing the safety bar

down will lock the bar. To unlock, lower the extension tray

and push in on the safety bar. This will release the flange

and allow the safety bar to move freely.

Figure 4.4, Safety bar components (72854S)

4.3 HYdraulic Feed mainTenance

noTe: check the reservoir daily for proper fluid level, the

presence of water (noted by a cloudy to milky appearance,

or free water in bottom of reservoir), and rancid fluid odor

(excessive heat).
The hydrostatic pump normally does not require regular

fluid changes. The system filter should be changed at

either 250 hour or annual intervals, whichever comes

first. The fluid and filter should be changed and system

cleaned if the fluid becomes contaminated with foreign

matter (water, dirt, grease, etc.) or if the fluid has been

subjected to temperature levels greater than the maximum

recommended.
There is a greaseable bearing on each side of the main

jack shaft on the main hydraulic feed housing. Grease

periodically.

This manual is related to the following products: