Echo 71854 - Manual (Page 13)

8 INCH PTO CHIPPERS 11
1. Three point hitch connection: Mounts chipper to
tractor 3 pt. hitch.
2. PTo shaft: connects chipper to tractor PTO shaft.
avoid driveline angles over 20 degrees on PTO shaft
when unit is in use. NOTe: Minimum and maximum
telescoping on the PTO shaft is 20.08" to 26.93". This
will leave a 6.85" overlap.
3. drive belt shield: Never remove shield while machine
is running.
4. chipper chute: feeds materials to the chipper blades
for chipping.
3.1 conTrols
Figure 3.1.1, Chipper controls
conTrols & oPeraTion
Section
5. leg stands: Never move machine unless the 3 point
is lifted and legs clear the ground.
6. rotor access cover: Tilts up to remove chipper blades
and to service rotor assembly.
7. discharge tube: chipped materials will exit through
this tube. It is adjustable 360 degrees. The discharge
tube for the 76854 model is not adjustable. It is de-
signed to blow materials onto the ground.
8. adjustable chipping anvil: Adjusts to change the size
of the chips.
9. rotor shaft bearing cover: covers rotor shaft and
front bearing.
3