Verification, Powering off and restarting, Verification powering off and restarting – IOGear GHSW8242 Manual User Manual
Page 16
16
The following table shows the available command list:
Command
Control
Enter
Description
pod
on
[Enter]
POD enabled (default)
pod
off
[Enter]
POD disable
Verification
After entering a command, a verification message appears at the end of the command line as
follows:
• Command OK - indicates that the command is correct and successfully performed by the
switch
• Command incorrect - indicates that the command has the wrong format and/or values.
Powering Off and Restarting
If you power off the GHSW8242, follows these steps before powering it on again:
1. Power off the attached devices.
2. Unplug the power adapter cable from the GHSW8242.
3. Wait 10 seconds, and then plug the power adapter cable back in.
4. After the GHSW8242 is powered on, power on the attached devices.
- GUWA200 (30 pages)
- GCS1804 (56 pages)
- GCS1804 (56 pages)
- GCS634U-PLUS (22 pages)
- GCS1782 (44 pages)
- GUWH104KIT (38 pages)
- GCS1794 (40 pages)
- GUB211W6 (30 pages)
- GCS12 (18 pages)
- GCS12 (34 pages)
- GCS932UB (32 pages)
- GCS1734 (44 pages)
- GCS124U (32 pages)
- GCS82B Manual (28 pages)
- GCS1762 (45 pages)
- GCS1764 (46 pages)
- GCS602 (22 pages)
- GCS1758 (54 pages)
- GCS138KIT (33 pages)
- GCS1714 (32 pages)
- MINIVIEW GCS1774 (3 pages)
- GUIP204 v1 (56 pages)
- GCS1744 (48 pages)
- GCS661U (36 pages)
- GCS661UW6 (32 pages)
- GCS1774 (45 pages)
- GUH284R (17 pages)
- GHPB42W6 (75 pages)
- GCS82B/GCS84B (29 pages)
- GUWH204KIT (40 pages)
- GCS614A Manual (26 pages)
- MINIVIEW GCS52U (24 pages)
- GBU221P (60 pages)
- GBC201 (45 pages)
- GBGPS201 (51 pages)
- GBGPS201 (118 pages)
- GBGPS201 (21 pages)
- GBHFK211W6 (1 page)
- GBHFK231W6 (36 pages)
- GBHFK331 (36 pages)
- GBMH201 (32 pages)
- GBMA211W6 (1 page)
- GBMH221 (1 page)
- GBP201 (26 pages)
- GBP301 (40 pages)