IOGear GHSW8242 Manual - Manual (Page 15)

15
CEC Commands
Consumer Electronics Control (CEC) allows interconnected HDMI devices to communicate and
respond to one remote control. The formula for CEC mode selection commands is as follows:
CEC Command + Control [Enter]
The following tables show the possible values and formats for the Control command:
Command Description
cec Enable CEC selection
Control Description
off Disable CEC
auto Apply the video source’s CEC to all display output
port 1 Apply the video source’s CEC only to port 1 (default)
The following table shows the available command list:
Command Control Enter Description
cec off [Enter] CEC off
cec auto [Enter] Connect the video source’s CEC with all display output
cec port 1 [Enter] Apply the video source’s CEC only to port 1 (default)
Power On Detection (POD)
The Power On Detection feature is turned on by default.
The formula for Power On Detection commands is as follows:
Power On Detection + Control command [Enter]
For example, to turn off the Power On Detection feature, input the following:
pod off [Enter]
Command Description
pod Power On Detection command
Control Description
on Turn on (default)
off Turn off
Note: Each command string can be separated with a space.
The following tables show the possible values and formats for the Control command: