I.R.I.S. Readiris 14 for Mac User Guide User Manual

Page 25

Section 2: Getting Started

IRISCard Anywhere / IRIScan Anywhere / IRIScan Book
scanners

You do not need to install any drivers when using these scanners.
They are not Twain driver-based scanners that can be used from
within any application to scan documents. Instead, they are
designed to be used on their own, disconnected from any computer.
The documents you scan are stored in the scanner’s internal
memory (or optional SD card / USB flash drive). From there, they
can be loaded directly into Readiris when you connect the scanner
or insert the SD card or USB flash drive into your Mac.

To check if the scanner driver has been installed successfully:

 In the Readiris menu, click Preferences.

 Click the Scanner tab.

 You should see your scanner listed*.

*This is not the case for the IRISCard Anywhere, IRIScan
Anywhere and IRIScan Book scanners.

If your scanner is not listed, its driver has not been installed
successfully.

Note that the IRIScan settings at the bottom are only available if
an IRIScan Express 2 scanner is connected.