JLG 800A_AJ Service Manual - Manual (Page 110)

SECTION 3 - CHASSIS & TURNTABLE
3-54 – JLG Lift – 3120858
4. Returning the Hub (1G) to locate on the large diame-
ter end, the Output Shaft (1A) is carefully installed
into the Hub (1G).
5. The Shaft Seal (1B) is installed over the Output Shaft
(1A) and into the counterbore of the Hub (1G). Care
should be taken to insure the Seal (1B) is being cor-
rectly installed (smooth face UP and located just
flush with the counterbore face).
6. The Bearing Cone (1F) is an interference fit and has
to be pressed or tapped on.
7. Pipe Plugs (1J & 1K) should be checked and/or
installed at this time in the assembly.