JLG X500AJ Operator Manual - Manual (Page 40)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-6 – JLG Lift – 3121636
2. In the platform, slide the control station assembly
into the storage box, on the right side of the con-
trol station ensure the attached flexible cable
slides into the slot in the box. Now place the rib on
the right side of the control station assembly
under the metal tab attached to the storage box
assembly.
3. Lower the control station assembly further into the
storage box, and secure the left side of the control
station by turning the thumbscrew on the locking
tab clockwise locking the rib of the control station
under the rotating metal tab of the thumbscrew.
4. To remove the control station assembly, reverse
the three steps above.
NOTE: The Platform/Remote control box may also be used to
operate the tracks, outriggers and track widening (if
equipped) by removing it from the platform while still
connected to the flex cable. All boom functions will be
disabled when the platform/remote box is operated in
this manner.