JLG X500AJ Operator Manual - Manual (Page 146)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-36 – JLG Lift – 3121636
78
VACC not OK
Cause –
Solution – This is generally a temporary problem due to certain working
conditions. If problem persists, replace inverter.
79
Incorrect start
Cause – Incorrect starting procedure.
Solution – Check electrical connections. This is generally a temporary
problem due to certain working conditions. If problem persists, replace
inverter.
86
Pedal wire KO
Cause –
Solution – This is generally a temporary problem due to certain working
conditions. If problem persists, replace inverter.
93
Wrong set batt
Cause – With power connected, battery test detected incorrect batteries
fitted.
Solution – Replace batteries with the original ones supplied directly by
JLG.
94
Current sensor KO
Cause – Set up procedure for maximum current in progress.
Solution – Contact JLG after-sales service.
Table 6-10. Inverter Fault Codes
CODE DESCRIPTION
99
Check up needed
Cause –
Solution – Contact Hinowa after.sales service.
Table 6-10. Inverter Fault Codes
CODE DESCRIPTION