Section 6. emergency procedures, 1 general information, 2 emergency operation – JLG 41AM Operator Manual User Manual
Page 81: Operator unable to control machine, Platform caught overhead, Righting of tipped machine, Section - 6 - emergency procedures, General information -1, Emergency operation -1

SECTION 6 - EMERGENCY PROCEDURES
3121211
– JLG Lift –
6-1
SECTION 6. EMERGENCY PROCEDURES
6.1
GENERAL INFORMATION
This section explains the steps to be taken in case of an emer-
gency situation while operating the machine.
6.2
EMERGENCY OPERATION
Operator Unable to Control Machine
IF THE PLATFORM OPERATOR IS PINNED, TRAPPED OR UNABLE
TO OPERATE OR CONTROL THE MACHINE, USE THE FOLLOWING
INSTRUCTIONS AS A GUIDELINE.
1. Other personnel should operate the machine from
ground controls only as required.
2. Only qualified personnel in the platform may use the
platform controls. DO NOT CONTINUE OPERATION IF
CONTROLS DO NOT FUNCTION PROPERLY.
3. Cranes, forklift trucks or other equipment can be used
to remove the platform occupant and stabilize motion
of the machine.
Platform Caught Overhead
If the platform becomes jammed or snagged in overhead struc-
tures or equipment, rescue the platform occupant prior to free-
ing the machine.
Righting of Tipped Machine
Before righting a tipped machine, check machine for any dam-
age which may prevent it from setting properly on its base
wheels once in a vertical position, (i.e. base wheels damaged,
base frame distorted, etc.). Use a crane, forklift or other suitable
lifting equipment and carefully lift the machine to an upright
position.
NOTICE
FOLLOWING ANY INCIDENT, THOROUGHLY INSPECT THE MACHINE AND TEST
ALL FUNCTIONS. DO NOT LIFT ABOVE 10 FEET (3 METERS) UNTIL YOU ARE
SURE THAT ALL DAMAGE HAS BEEN REPAIRED, IF REQUIRED, AND THAT ALL
CONTROLS ARE OPERATING CORRECTLY.