Section 3. machine controls and indicators, 1 general, 2 controls and indicators – JLG 41AM Operator Manual User Manual
Page 29: Ground control station, Section - 3 - machine controls and indicators, General -1, Controls and indicators -1, Ground control station -1
SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121211
– JLG Lift –
3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1
GENERAL
NOTICE
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE APPLICA-
TION AND OPERATION. THE USER AND OPERATOR ARE RESPONSIBLE FOR
CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2
CONTROLS AND INDICATORS
Ground Control Station
(See Figure 3-1.)
NOTE:
For overnight parking or battery charging, be sure the
POWER ON/OFF KEY SWITCH is positioned to OFF to pre-
vent battery drain.
1. POWER ON/OFF Key Switch
A key switch located on the ground control station controls
power to all functions on the machine.
2. POWER/EMERGENCY STOP
The two position switch allows power to the platform and
ground controls when RESET (ON). When pushed in (OFF),
power is shut off to the platform and ground controls.
3. HYDRAULIC RESERVOIR / CIRCUIT BREAKER / FUSE
(located inside the ground control station housing)
The hydraulic oil level can be checked through an access
hole in the side of the cover.
NOTE:
Check hydraulic oil only when platform is completely low-
ered and after cycling platform up/down a few times.