JLG 4017PS Operator Manual - Manual (Page 63)

Section 3 - Controls and Indicators
3-19 31200753
Attachment Functions
Attachment tilt is controlled by the roller switch (5).
• Push the roller switch up to tilt attachment down; push the roller switch down to
tilt attachment up.
Auxiliary Hydraulic Functions
Auxiliary Hydraulics roller switch (6) controls function of attachments that require
hydraulic supply for operation. See Section 5 - Attachments and Hitches for
approved attachments and control instructions.
Boom Float Function (3706PS & 3707PS, if equipped)
Joystick trigger button (7) controls boom float. Boom float allows free movement of
boom (lift/lower) while the attachment follows ground contours.
• With boom retracted and lowered, press and hold the button; move the joystick
forward to activate boom float. Button and joystick position must be held to
maintain boom float.
• Release button to deactivate boom float and move joystick to neutral position.
Outrigger Functions (4014PS & 4017PS)
Joystick trigger button (7) controls both outriggers.
• Press and hold the button; move the joystick forward to lower both outriggers;
move the joystick back to raise both outriggers.
• Press and hold the button; move the joystick left then forward to lower the left
outrigger; move the joystick left then back to raise the left outrigger.
• Press and hold the button; move the joystick right then forward to lower the right
outrigger; move the joystick right then back to raise the right outrigger.
• Outriggers operable with boom at any extension and below 20 degrees or with
boom fully retracted and below 55 degrees.
WARNING
TIP OVER HAZARD. Outriggers increase stability and load capacity only if they
are used properly. Using outriggers on soft surfaces could cause telehandler to
tip over. Always ensure surface can support telehandler and load.