JLG 4017PS Operator Manual User Manual
Page 137
Section 5 - Attachments and Hitches
5-45
31200753
To open/close bucket gate:
The attachment auxiliary hydraulic roller switch (3) controls the bucket gate.
• Push roller switch down to open gate.
• Push roller switch up to close gate.
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on
• Secure the concrete bucket to the forks by sliding the concrete bucket onto the
parent forks and install the retaining pin behind the vertical shank of the fork.
Operation:
• Close bucket gate, level bucket and fully retract and lower boom to load material.
• Distribute material evenly within the bucket. Bucket capacity charts are for evenly
distributed loads only.
• Load center will vary depending on the amount of material in the bucket. Always
ensure compliance with the capacity chart.
• Travel in accordance with requirements set forth in Section 1 - General Safety
Practices.
• Position bucket and open bucket gate to release load.
Equipment Damage Precautions
• Transport the concrete bucket as low as practical at a slow speed and without
rapid side to side movement.