JLG 4017PS Operator Manual - Manual (Page 55)

Section 3 - Controls and Indicators
3-11 31200753
Park Brake
The park brake lever (1) controls the application and release of the park brake.
If Equipped with Mechanical Park Brake
• Pull lever back to apply park brake.
• Squeeze release (2) and push lever forward to release park brake.
If Equipped with Hydraulic Park Brake
• Pull lever back to apply park brake.
• Lift detent ring (3) and push lever forward to release park brake.
Parking Procedure
1. Using service brake, stop telehandler in an appropriate parking area.
2. Follow “Shut-Down Procedure” on page 4-3.
WARNING
MACHINE ROLL-AWAY HAZARD. Always move park brake lever to "ON"
position, lower boom to ground and stop engine before leaving cab.
WARNING
CRUSH HAZARD. Applying park brake while traveling will cause unit to stop
abruptly and could cause load loss. To stop the machine in an emergency, apply
the park brake.
OAM1600
2
1
OZ4290
3
1
IF EQUIPPED WITH
MECHANICAL PARK BRAKE
IF EQUIPPED WITH
HYDRAULIC PARK BRAKE