Eppendorf S Series 48S CO2 Incubator - Manual (Page 12)

12
CO48S-0050 Š Galaxy S Series 48 S Personal Size CO
2
Incubator User’s Guide
Table 1: Accessories Provided
Quantity Item Notes
3 Non-tip Shelves Packed Separately
2 Wire Shelf Racks Packed Separately
1 Humidity Tray Packed Separately
14 Silicone Rubber Suction Feet Installed
1 White porous CO
2
Sensor Cover Installed
1 Black Sensor Cover* Installed
1 Power Cord Packed in accessories bag
3 meters,
9.8 feet
PVC Tubing, ~1/4-inch or 6mm bore, with an
inline CO
2
HEPA-filter connected, ready for use
Packed in accessories bag
2 Hose Clips Packed in accessories bag
1 AutoZero HEPA Filter Packed in accessories bag
4 Adjustable Feet Packed in accessories bag
4 Anti-slip Pads for adjustable feet Packed in accessories bag
1 User Manual Provided
* There is a holder at the rear of the incubator to store the black sensor cover.
WARNING!
Anytime you touch or handle the white CO
2
sensor cover, be sure to
wear gloves, and do not later touch those gloves to your face. Discard
or wash the gloves.
2.3 Utilities
In order to use the incubator, you will need:
Table 2: Utilities
Utility Requirement
100/120V, 50/60 Hz grounded electrical supply with minimum capacity of 6
amps (or 8 amps for High Temperature Disinfection Models)
OR
Electricity
220/240V, 50 Hz grounded electrical supply with minimum capacity of 3 amps
(or 5 amps for High Temperature Disinfection Models)
CO
2
Gas Cylinder with 100% CO
2
vapor withdrawal, together with a two-stage regulator
for pressure control to 5 psi or 0.35 bar
WARNING!
For proper incubator operation, CO
2
gas pressure must not exceed 5 psi.