Eppendorf ThermoStat plus - Manual (Page 19)

5 Operation
21
ThermoStat plus — Operating Manual
5.4.2 Programmable temperature control
In addition to simple tempering you can also create a program with up to 4 different phases which
are sequenced automatically. You can set the desired temperature and the desired tempering
duration.
1. Switch the device on.
On the display, the nominal temperature is displayed on the left, the actual temperature on
the right.
2. Press "Prog" for approx. 1 second.
On the display the phase (P1) appears on the left and to the right of it the target and actual
temperatures. In the bottom line the tempering duration is shown.
3. Set the desired temperature using the "Temp." arrow keys.
Hint!
If the time is enabled you have to disable it to enter programmable tempering.
20° C 20° C 37° C P1
00h: 30m
20° C
95° C P2
00h: 05m
20° C
Progr.
Progr.
70° C P3
00h: 20m
20° C
Progr.
4° C P4
--h: --m
20° C
Progr.
95° C T1-2
00h: 00m
20° C
Progr.
70° C T2-3
00h: 00m
20° C
Progr.
4° C T3-4
00h: 00m
20° C
95° C T1-2
01h: 52m
20° C
70° C T2-3
00h: 50m
20° C
4° C T3-4
MIN:
MIN:
MIN:
02h: 12m
20° C
Progr.
Temp. Time
Temp. Time
Temp. Time
Temp. Time
Time
Time
Time
Time
Time
Time
EN
Operating Manual