Eppendorf ThermoStat plus - Manual (Page 13)

4 Installation
15
ThermoStat plus — Operating Manual
4 Installation
4.1 Preparing installation
 Check the completeness of delivery based on the details of the scope of delivery
.(see Delivery package on page 9)
 Check all parts for any transport damage.
4.2 Selecting location
Select a location for the ThermoStat plus in accordance with the following criteria:
•
Mains power connection (230 V/120 V) as per device identification plate. This is located on
the rear side of the device.
•
At least 10 cm away from adjacent devices and walls.
•
Solid bench with stable, horizontal and even work surface.
4.3 Installing instrument
1. Place the ThermoStat plus on a suitable work surface so that the ventilation slots on the base
of the device are not blocked.
2. Connect the power cable supplied to the mains connection socket (7) of the ThermoStat plus
and the power supply (see Fig. 1 on page 9).
3. Switch on the ThermoStat plus using the mains switch (5) (see Fig. 1 on page 9).
4. Fit the exchangeable thermoblock (see Inserting exchangeable thermoblocks on page 17).
Hint!
Retain the transport carton and the packing material for subsequent safe transport or
storage.
WARNING!
Warning! Damage due to incorrect power supply.
 Only connect the device to power sources that match the electrical specifications on
the device's nameplate.
 Use only sockets with protective earth.
EN
Operating Manual