Eppendorf Top Buret M / H - Manual (Page 19)

19
Installation
Top Buret ™
English (EN)
Proceed as follows:
1. Push the inner tube completely out of the outer tube.
2. Shorten both tubes to the required length using a pair of scissors.
3. Insert the inner tube into the outer tube.
4.3.3 Mounting the telescopic aspirating tube
4.4 Mounting the Top Buret on the bottle
Abb. 4-3: Sliding the telescopic aspirating tube onto the connection opening
Fig. 4-3: Sliding the telescopic
aspirating tube onto the
connection opening
1. Slide the inner tube onto the
connection opening up to the stop.
2. Pull out the outer tube so that it
stops short of the bottom of the
bottle.
3. Cut the lower end of the outer tube
off at an angle.
CAUTION! Personal injury due to incorrect transportation of buret.
If the mounted buret is not transported properly, reagents may be
released. Contact with reagents may be harmful to eyes or skin.
 To transport the mounted buret, grasp the buret with one hand and
the bottle with the other hand.
 Do not hold the buret by the housing.