Eppendorf FemtoJet 4x v.2 - Manual (Page 20)

Installation
FemtoJet
® 4x
English (EN)
20
4 Installation
4.1 Preparing installation
1. Check the packaging for damage.
2. Check that everything is included in the delivery.
3. Check the Microinjector and the accessories for damages.
4.1.1 Complaints about damages
Contact your local Eppendorf distribution partner.
4.1.2 Incomplete delivery
Contact your local Eppendorf distribution partner.
4.2 Selecting the location
Select the device location according to the following criteria:
• Suitable mains/power connection in accordance with the name plate.
• A bench with a horizontal and even work surface which is designed to support the
weight of the device.
• Connection for external compressed air supply according to technical data.
4.3 Connecting the external pressure supply
You can use the following external pressure supplies:
• Compressor
• Compressed gas cylinder with industrial gas
• Compressed air supply by domestic services
The external pressure supply must provide for a constant pressure according to the
technical data. You may use compressed air or nitrogen gas.
The gases must meet the following quality criteria:
• Compressed air – oil-free, clean and dry
• Nitrogen gas – cleaned
Store the packaging for later transport or storage.
In case of visible damages on the Microinjector or the packaging, do not
commission the Microinjector.
The mains/power switch and cutting unit of the mains/power line must be easily
accessible during operation (e.g., residual current circuit breaker).