Eppendorf Mastercycler nexus - Manual (Page 74)

System management
Mastercycler
® nexus
English (EN)
74
8.4.1 Cycler system functions
The System node contains the cycler system level with the following softkeys.
Status • Display the cycler operating status
• Display the temperatures of the thermoblock and the heated lid
• Display the remaining run time for the program
• Stop the program
Protocol Protocols of the last 20 program runs:
 Select the protocol via the arrow keys.
• Print softkey: print the protocol
• Export softkey: copy the protocol to a storage medium
• Show softkey: display the protocol
The following applies to devices with a thermoblock with 64+32 wells:
The Cycle functions comprise the
Properties , Overview , Status 64 and Status 32 softkeys.
The Incubate and Protocols softkeys are located under the subnodes Block 64 or Block 32 .
Info • Display the device name
• Display the date of the last verification
• Display the date of the last verification
• Display the programs run (since the last verification)
• Display the date of the last self-test
• Display the date of the next self-test
• Display the programs run (since the last self-test)
• Display the date of the last adjustment
Details about the next verification or self-test are only given if the settings have been
made under
Service intervals ((see p. 70)).
Restart Entry for maximum duration of interruption of voltage supply ( mm:ss ) after which a
running program should be automatically restarted. The program is not restarted after
a longer interruption.
Sensors Display current sensor temperatures for the control loops of the thermoblock and the
heated lid.