Eppendorf Mastercycler nexus - Manual (Page 54)

Programming
Mastercycler
® nexus
English (EN)
54
5. Press the Insert softkey.
The program step is inserted with standard parameters.
You can now insert additional program steps or edit the parameters of the program steps.
6.3.2 Editing parameters
1. Mark the desired program step with the arrow keys.
The marked program step is highlighted in blue.
You can change the temperature, holding time and number of cycles directly in this view.
2. Press the enter key to accept the changes.
Extended options
3. Press the Options softkey.
The extended parameter settings for the marked program step are displayed.
Pause As Hold . The block temperature remains set to the value of the previous temperature
step.
Temperature Adjustable from 4.0°C to 99.0°C (in 0.1°C increments)
Dwell time Adjustable from 000:00 to 999:59 (mmm:ss) in 1-second
steps
Number of cycles Adjustable from 1 to 99
Temp Temperature of the program step