Advance Adapters 50-5043 - Manual (Page 3)

ADVANCE ADAPTERS INC. P/N: 50-5043
P.O. Box 247, 4320 Aerotech Center Way New Item: (06/05)
Paso Robles, CA 93447 PAGE 3 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-05-13
1410 NON CV VSS
TAILHOUSING RELUCTOR KIT
3. Locate the sensor, and start it into the block. Place the ring over the tailhousing. You will notice that the ring can
be rotated to any position. Make note of the location of the floorboard, skid plate, exhaust, etc. Choose a position
that will be clear of any objects/heat. Position it so it sits evenly on the tailhousing. Screw in each set screw lightly,
one at a time. Please start with very light pressure until all have been started. Go over all the set screws 2-3 times
until they are all tightened evenly. Double check to make sure that the ring is still sitting properly.
4. Find your new yoke. You will notice that the reluctor ring has been pressed onto the yoke by Advance Adapters.
Do no attempt to move, relocate, or disturb the reluctor ring; it has been positioned specifically for your kit. Place
the yoke "driveshaft side down" on a bench. Apply a small bead of silicon to the internal splines. Make sure the
bead makes it all the way around the inside perimeter. Start the yoke onto the output shaft. Do not push it all the
way on. You should push the yoke on just far enough so that the threads are accessible for the nut. Take the nut
and start it by hand. You will notice that it gets difficult after the first couple of turns. Use a 1-1/8" socket and fully
tighten the nut. If you are doing the VSS installation with the transfer case still in the vehicle, torque the nut to 150
ft./lbs. If you are doing the installation in a bench, do your best to get it tight; do the final torque on the nut when
the transfer case is in the vehicle.
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to
any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be
required to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet
is only to be used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained
for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts
stores.