Advance Adapters 50-5042 - Manual (Page 4)

ADVANCE ADAPTERS INC. P/N: 50-5042
P.O. Box 247, 4320 Aerotech Center Way New Item: (06/05)
Paso Robles, CA 93447 PAGE 4 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-21-05
1350 NON CV VSS
TAILHOUSING RELUCTOR KIT
5. Tighten the top and non-slotted socket head cap screws. Please verify that the bolt (that has a slot through it) needs
to be loose. Thread the sensor down until it gets close to the reluctor ring. Use a feeler gauge to set a gap of 0.012"
+/-0.002". Make certain that the probe of the sensor is lining up with the top of one of the teeth on the reluctor ring.
Spin the shaft and recheck this gap at two more locations on the reluctor. Once the gap has been set, snug the
loose retaining bolt. Verify that the sensor has not moved by using the feeler gauge. Also make sure that the bolt
is snug enough that the sensor is not able to spin in the mounting block.
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to
any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be
required to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet
is only to be used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained
for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts
stores.