Advance Adapters 50-5041 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 50-5041
P.O. Box 247, 4320 Aerotech Center Way New Item: (6/05)
Paso Robles, CA 93447 PAGE 2 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 03-24-09
1310 CV VSS
TAILHOUSING RELUCTOR KIT
for any given moment. Overall, having an operational VSS on a late model engine will yield the best performance possible.
Some products may try to "trick" or mask this signal; the Advance Adapters TruPulse kit uses factory GM sensors to
give a genuine signal to the computer. Please make sure that your harness and computer are programmed to accept
this signal.
GETTING STARTED:
Please take an inventory and become familiar with the parts included in the kit. Do not substitute any parts. If there
is a shortage or if you have any questions please call us at 1-800-350-2223. Also, make sure all parts are clean and
free of any loose debris. Be sure that you have an Advance Adapters upgrade kit installed on the transfer case. Only
basic hand tools are required other than a torque wrench and possibly a yoke puller (a dead-blow hammer can be
substituted when attempting to remove the transfer case yoke).
DISASSEMBLY:
NOTE: You may find it easier to install this kit by removing the transfer case from the vehicle. If so, consult the owner's
manual for instructions.
1. Start by removing the rear driveshaft and yoke from the transfer case and set aside.
2. Please remove the seal from the housing and discard.
3. Clean the output shaft and related parts and make sure there is no debris. Also take the chance to clean the outside
machined surface on the tailhousing to prepare it for the tailhousing ring.
ASSEMBLY:
1. Please find the new seal provided in the kit. Tap the seal into the
tailhousing. Use even pressure to prevent distortion of the seal
face. The seal should be pressed to the bottom of the seal bore
in the tailhousing which is approximately 1/8" below flush with the
tailhousing. Please take a small dab of grease and/or oil to
lubricate the lip portion of the seal.
2. Locate the sensor mounting block and ring. Install the three set screws into the ring and
mount the sensor block to the ring. At this time tighten the block bolts in finger-tight only.