Advance Adapters 716286 - Manual

ADVANCE ADAPTERS INC. P/N: 716286
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-24-03
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No.
Qty Part No. Description
Optional items
1. 1 716286-BLK BRACKET ASSEMBLY
2. 1 716139 FORK WEDGE
3. 1 716215 SLAVE CYLINDER FITTING
4. 1 720015 10mm FLAT WASHER
5. 2 723704 3/8" LOCK WASHERS
6. 2 723705 3/8"-24 JAM NUTS
7. 2 723725 3/8"-16 x 1-3/4" H.H.C.S.
8. 1 723771 3/8"-24 x 9" ALL THREAD (Before shipping, all thread must have radius' on both sides)
CLUTCH SLAVE CYLINDER AND BRACKET
FOR GEN. III V8s WITH TRUCK MANIFOLDS
INSTALLATION INSTRUCTIONS:
This bracket is designed for use on the GEN. III Vortec V8s. This slave cylinder bracket should only be used with a
our NV4500 full bellhousings. The slave cylinder location is close to the exhaust port of the Vortec engine so we
recommend some type of heat shield to made and installed around the slave cylinder.
The metric washer must be installed between the bellhousing and the bracket lower hole. This washer is a spacer
because the bellhousing is spot-faced on that lower hole location.
This slave cylinder bracket is
designed to fit our slave cylinder,
P/N 716213