Advance Adapters 716340 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 716340
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 03-01-10
1. 1 716130 YJ MASTER CYL. FITTING (PIN-TYPE)
2 1 716130F EARLY YJ MASTER CYLINDER FITTING
3. 1 716130-60 60" HYD. HOSE
4. 2 716130TJ TJ MASTER CYLINDER FITTING & SLAVE CYLINDER FITTING
5. 1 716341 TJ STYLE JEEP SLAVE CYLINDER
6. 2 723134 5/16"-18 x 1-1/4" H.H.C.S.
NOTES:
This slave cylinder assembly is
used on Jeeps with the NV3550
bellhousing. The bellhousing
assembly Part Number is 712590.
JEEP SLAVE CYLINDER ASSEMBLY
FOR NV3550 BELLHOUSING
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of
the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete
your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly
of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams
and other related equipment. These manuals are normally available at automotive dealerships and parts stores.
NV3550 BELLHOUSING SLAVE
CYLINDER MOUNT
NEW SLAVE CYLINDER NEW SLAVE CYLINDER INSTALLED
Instructions:
This new slave cylinder is designed to work with the stock master cylinders found in the CJ, YJ, and TJ Jeeps. The slave
cylinder included in this kit does not have a bleeder valve to prime the hydraulic system. To prime the hydraulic system.
Push the slave cylinder rod inward and disconnect both bands of the retaining strap. Let the push rod fully extend. Do
not cut or discard the retaining straps.
Tilt the slave cylinder at a 45 degree angle. The hose connection fitting should be facing upward. Pour the hydraulic fluid
into the slave cylinder until full. With the slave cylinder still at an angle, insert the slave cylinder fitting, o-ring and hose.
Install the retaining pin to secure the new assembly to the slave cylinder. Connect the hose to the master cylinder.
Hold the slave cylinder vertically with the push rod facing the ground. The slave cylinder must be lower than the master
cylinder. Slowly push the slave cylinder push rod inward approximately 1" while watching for the air bubbles into the master
cylinder reservoir. After about 10 to 15 strokes all air bubbles should be gone.
With the master cylinder cap off, slowly push the slave cylinder rod inward
and reconnect the plastic straps. install the slave cylinder on to the
bellhousing. The straps will break off when the clutch is depressed the first
time.