Advance Adapters KJ09126BK User Manual
Page 2
KJ09126 1997-2006 Jeep TJ/LJ Rock Krusher
3” Coil Spring Spacer Lift Kit
Instruction Sheet P10862-00
© 2008 Daystar Products International Inc.
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
hoenix, AZ 85043
P
8.
Remove one spring (mark or note orientation before removal), take old bump stop off, and remove
steel bump stop mount and old OE spring isolator. Fig 4,5,6.
9.
Install the new isolator (M03606)
10.
Using the spring compressor compress spring enough that it can be placed back into position.
11.
Install spring while holding new bump stop inside of spring. Install the new bump stop
when the spring is in place. Next, decompress the spring. Fig. 7
12.
Repeat steps 7-10 for the other side of the vehicle.
13.
Front track bar relocation. Drill a new 7/16 diameter mounting hole in the track bar’s axle bracket,
where shown. Shift the axle assembly as necessary to align the track bar eye with the new hole.
Insert the stock fastener and tighten. Fig 8 page 3
14.
Repeat all installation steps on rear suspension. Fig. 9, and Page 4.
15.
Torque all bolts to factory specifications. Re-torque all bolts after 500 miles
Fig.1