Advance Adapters KJ09152BK - Manual

www.DaystarWeb.com
Tech Support Contact Info
[email protected]
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71 st Avenue
Phoenix, AZ 85043
Instruction Sheet
2009 Daystar Products International Inc.
Instruction # P20314 09/08/09
2007-2010 Jeep Wrangler JK Lift. KJ09152 Front only
Tools need for installation.
1. Floor jacks , jack stands and wheel chocks.
2. Metric
tools.
Bill of Materials
BOM for 1 1/2 kit
M20313 x 2 Ft spacers
1. Check the BOM for all parts and lay out the tools.
2. Jack up the front of the vehicle and support the vehicle at the frame with jack stands. Put
wheel chocks behind the rear tires.
3. With the jack under the front axle jack up the axle and remove the front wheels . Discon-
nect the shocks and sway bar end links and lower the axle and remove the springs.
4. Install the front spacers over the stock isolators and reinstall the front coils. Jack up the
front axle and reinstall shocks and sway bar end links.
5. Put the front tires on and remove jack stands and put back on the ground.
6. You need to have your wheel alignment checked.
7. Check all bolts after 500 mil es.
WARNING
This vehicle has been modified to enhance its performance. The steering, braking and handling of this vehicle will differ from standard passenger cars and
trucks, This vehicle handles differently from an ordinary vehicle in driving conditions which may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving conditions that could cause loss of control, possibly leading to a roll over or
other accident that could result in serious injury or death to driver and passengers. If larger tires are installed the speedometer will read lower than the vehicles
actual speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES