Advance Adapters 716008 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 716008
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-29-01
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to
any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required
to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be
used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque
values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts stores.
1. 1 Kit 713010-NS NEO-PRENE MOUNTING KIT
2. 1 716008-PLT MOUNTING PLATE
3. 2 723722 H.H.C.S. 3/8"-16 x 1-1/4" LONG
4. 2 723735 3/8" FLAT WASHERS
5. 2 724303 7/16" LOCK WASHER
6. 2 724349 H.H.C.S. 7/16"-14 X 1-1/2" LONG
NEW TRANSMISSION CROSSMEMBER SUPPORT
NP231 WRANGLER VEHICLES
NOTE: This transmission support mount is designed around the use of the Advance Adapters
transmission to transfer case housings. When used on Wrangler transfer case kits, the original
transmission support and snubber can be eliminated. New holes will need to be drilled into the skid
plate. We have provided four different hole locations for your selection. If necessary, new holes
could be drilled at a different location. Once the mount is on the adapter housing, you will then be
able to locate the holes in the skid plate area. On some installations that require additional skid plate
clearance, it may be necessary to use some square structural tubing between the adapter and new
crossmember bar. We have illustrated this in the optional design drawing illustrated below. On CJ5
and CJ7 vehicles 1980-86, we use a similar kit Part No. 716021 that offers a narrower stance.
SPECIAL NOTE: As of 05-27-99, the rubber mount kit has been changed to a 1-1/4" index hole. Kits
purchased before this date will require a 1-1/8" index hole, P/N 713008-NS.