beautypg.com

Advance Adapters 716021 User Manual

Page 2

background image

ADVANCE ADAPTERS INC.

P/N: 716021

P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447

PAGE 2 OF 2

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

12-18-06

NEW TRANSMISSION CROSSMEMBER SUPPORT

DANA 300 1980-86 VEHICLES

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to

any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required

to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be

used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque

values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts stores.

NOTES:

1. Two (2) new holes will need to be drilled through the skid plate

for rubber mounts.

2. Smaller rubber mounts must be placed inside tubing before

inserting 5/8" bolt.

This mount (Part #716021), is designed for 1980-86 Jeeps

only. It has been designed around the use of Advance

Adapter transmission to transfer case housings.

Please note:

The torque spec. will vary depend-

ing on the condition of the nyloc nut.

A new nyloc nut should be torqued

to 100 in./lbs. (approx 8 ft./lbs).

Visually, the supplied washer should

become "sunk" into the top of the

small rubber mount. Once the

washer "disappears slightly below

the rubber, you have reached a good

pre-load. Be aware that the tighter

the bolt is, the "harder" the rubber

will feel with power-train flex.