Advance Adapters 713124 - Manual

ADVANCE ADAPTERS INC. P/N: 713124
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-27-01
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 1 713008-NS MOUNTING HARDWARE KIT
2. 2 713044 SHORT SIDE BLOCK MOUNT
3. 2 713045 FRAME BRACKETS
4. 2 713124-PLT 3/16" THICK STEEL SCAB PLATES FOR FRAME
5. 1 723798 ENGINE MOUNTING HARDWARE PACKAGE
6. 1 TLC001 LAND CRUISER INSTRUCTION MANUAL
INSTALLATION INSTRUCTIONS:
These engine mounts are specifically designed for the Chevy V8 engine in the Toyota Land Cruiser vehicles. The mounts
include 2 individual steel scab plates that must be welded to the inner frame rails of the Toyota Land Cruiser. The exact
location of these scab plates may vary depending on which transmission combination is being used. Refer to the Land
Cruiser instruction manual for determining the best possible location, and be sure to consider all of the necessary
requirements before final engine location is determined.
To obtain the proper front driveshaft clearance the engine should be offset 1/2" to 1" to the driver's side of the vehicle.
TOYOTA LAND CRUISER
CHEVY V8 ENGINE MOUNTS
THE 5/8"-18 NYLON NUT SHOULD BE
TORQUED TO 25 TO 30 FT./LBS.