Dodge v8 universal weld-in mounts – Advance Adapters 713095 User Manual
Page 2

ADVANCE ADAPTERS INC.
P/N: 713095
P.O. Box 247, 4320 Aerotech Center Way
New Item: (11/02)
Paso Robles, CA 93447
PAGE 2 OF 2
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
10-10-08
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
DODGE V8 UNIVERSAL
WELD-IN MOUNTS
SPECIAL NOTE:
Modifications to the engine mount arm brackets may be necessary on certain installations. The mounts may need to be
shortened in order to fit between frame rails. The hole location for the rubber mount position may require a new hole or
slotting between two of the holes.
Remove the engine assembly and fully weld the mounts to the frame. Once the frame mounts are welded into position,
the Dodge engine can be reinstalled. We have provided new rubber indexing donuts for isolating the engine vibrations
from the frame and body. These rubber donuts index on the top and bottom of the frame mount. The large 5/8" bolt
is then inserted from the bottom of the frame mount up through the rubber mounts and the block mount. Once the block
is in the correct location and the rubber mounts are installed, tighten the 5/8" locknuts to 25-30 ft./lbs. to secure the
engine location.
DODGE 360 INSTALLATION NOTES:
The Dodge 360 driver's side mount is narrower than that of the Dodge 318. When using this mount on a 360, we have
included four 1/4" spacers. These spacers need to be installed between the block tabs and the block mount. We
recommend using two on the front side of the mount and two on the back side.