Advance Adapters 713018 - Manual

ADVANCE ADAPTERS INC. P/N: 713018
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-01-11
KIT CONSISTS OF:
No.
Qty. Part No. Description
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
OPTIONAL ITEMS:
Qty.
Part No. Description
INSTALLATION PROCEDURES:
These one piece motor mounts offer the easiest installation when installing the V-8 into the Bronco II and Ranger 4WD
vehicles. You will need to make two slots in your crossmember. This can be done with a saber saw or torch. Once
the holes are in place, install the motor mounts onto the crossmember. You will need two metric nuts to hold them
into position. Once the mounts are in place, you will need to mark and grind a clearance area for each mount where
the torque stud on the lower part of the mount interferes with the crossmember.
NOTE: Ford used a few different
crossmember configurations. Where you drill your holes may be different then the diagram below. This
diagram is just a guide.
BRONCO II, RANGER 4WD & 1991-94
EXPLORERS DELUXE ENGINE MOUNTS
1. 1 713018-L PASSENGER SIDE MOUNT
2. 1 713018-R DRIVER'S SIDE MOUNT
3. 2 713018-S METRIC NUTS
1 717044 V8 SLICK FIT HEADERS
1 716084 REMOTE OIL FILTER
1 716412 FORD DUAL SUMP OIL
PAN & PICKUP TUBE
1 716683 4-CORE RADIATOR
W/ COOLER
(FRONT)