Advance Adapters 920003 - Manual

ADVANCE ADAPTERS INC. P/N: 920003
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-26-12
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
KIT CONSISTS OF:
No. Qty. Part No. Description
SATURN OVERDRIVE SHIFT LINKAGE
UNIVERSAL SHIFT KIT
1. 1 715651 CLIP
2. 1 716140 BRAKE YOKE 3/8"WITH PIN
3. 5 722546 SHIFTER BOOT SCREWS
4. 2 723704 3/8" LOCKWASHER PLT.
5. 2 723723 H.H.C.S. 3/8"-16 x 1-1/2"
6. 1 920016 SHIFTER KNOB (SATURN)
7. 1 920017 WASHER
8. 1 920018 SHIFTER SNAP RING
9. 1 920019 SHIFTER HANDLE
10. 1 920021 SHIFTER BOOT DUAL HANDLE
11. 1 920022 SHIFTER BOOT RING DUAL HANDLE
12. 1 920035 SHIFTER LINKAGE ROD
13. 1 920036 SHIFTER BRACKET
14. 1 920039 1/4"-20 X 1 H.H.C.S.
15. 1 920040 1/4"-28 JAM NUT
16. 1 920041 HEIM JOINT 1/4"-28
17. 1 722514 1/4"-20 LOCKNUT
18. 1 303081 IGUS BUSHING (PRESSED INTO THE HANDLE)
This shifter is a universal application. Due to the various transmission options available, this kit should be used when
coupling a Saturn overdrive to a vehicle that is not equipped with the factory transmission. Some modifications to the
shift handle may be necessary on vehicles using a long transmission.
The pivot bracket is designed to bolt the top two holes of the transfer case. These two holes always remain the same
with any adapter used. Long transmission assemblies may relocate this bracket to far rearward, requiring some
modifications.
A sheet metal plate and rubber boot have been provided for your floorboard. An access hole may needed to cut the
floorboard for the new handle assembly.