Advance Adapters Ranger Reassembly - Manual (Page 2)

REMOVE THE SNAP RING FROM THE
CLUSTER SHAFT AND THE CLUSTER
BEARING SNAP RING. USE A BEARING
PULLER TO REMOVE THE BEARING FROM
THE CASE AND CLUSTER GEAR.
REMOVE THE SHIFT FORK FROM THE CASE. FOR REASSEMBLY WE HAVE PROVIDED A
DUMMY SHAFT TO RELOAD THE SHIFT BALL AND SPRING INTO THE SHIFT FORK. ONCE
THE SHIFT FORK IS LOADED, INSTALL THE DUMMY SHAFT TO RETAIN THE BALL AND
SPRING. YOU CAN THEN INSTALL THE FORK INTO THE CASE. AS THE SHIFT RAIL IS
INSTALLED FROM THE FRONT AND THEN ALIGNED INTO THE SHIFT, IT WILL PUSH THE
DUMMY SHAFT THROUGH THE REAR OF THE MAIN CASE RETAINING THE BALL AND SPRING
IN THE FORK.