Advance Adapters 50-3020A User Manual
Page 3

ADVANCE ADAPTERS INC.
P/N: 50-3020A
P.O. Box 247, 4320 Aerotech Center Way
New Item: (04/02)
Paso Robles, CA 93447
PAGE 3 OF 4
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
06-10-09
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
JEEP & SCOUT DANA 20 T/C TAILHOUSING
32 SPLINE OUTPUT WITHOUT YOKE
Stud bolt and nut being installed
on the new tailhousing
New tailhousing being installed. Be sure
to check spline alignment between our
shaft and your stock gear.
New tailhousing installed. The new bolts
need to be torqued to 30ft./lbs. Turn the
yoke to make sure the unit is not bound up
or is not binding.
to the stud bolt has a milled pocket into which the 3/8"-16 nut must be set into. As you assemble the tailhousing to the
case, thread the nut to the stud.
Fill your unit with the recommended oil.