Advance Adapters 715542 - Manual

ADVANCE ADAPTERS INC. P/N: 715542
P.O. Box 247, 4320 Aerotech Center Way New Item: (1/01)
Paso Robles, CA 93447 PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-07-13
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
KIT CONSITS OF:
No:
Qty Part No. Description
JEEP TJ & TJ RUBICON
TRANSFER CASE LINKAGE BRACKET
1. 1 715542-BLK BRACKET
2. 2 722532 1/4"-20 x 3/4" H.H.C.S.
3. 2 722514 1/4"-20 NYLON LOCK NUT
4. 2 723701 3/8"-16 NUT
5. 2 723704 3/8" LOCK WASHER
6. 2 723708 3/8"-16 x 2-1/2" STUD BOLT
7. 4 42r745 PLUGS (FLOOR BOARD)
NOTES:
This bracket is designed to fit Jeep TJs only. Jeep used two transfer case rotations. This bracket is designed
to fit the 13 degree rotation only.
Due to the various adapter configurations, some applications may require grinding on the bracket for proper fit
to the adapter housing.
INSTALLATION PROCEDURES:
1. Remove the transfer case shifter bellcrank linkage and remove the body support bracket.
2. The body support bracket is equipped with a bearing support This bearing support must be removed and reinstalled
on the new bracket.
3. Place the bellcrank between the stock transfer case bracket and the new bracket supplied.
4. Fit back into the vehicle over the stock two studs on the transfer case. Note: The stock studs may need to be
changed out to the longer studs provided.
5. The relationship of the bellcrank assembly to the front of the transfer case should remain the same; however, the
rod from the floorboard to the bellcrank will more than likely need to be lengthened or shortened depending on the
drivetrain adjustment.
Another options to upgrade the Jeep linkage is
to remove the bellcrank completely, We offer
a complete cable shifter for the Jeep Sports and
Rubicon transfer cases. See part numbers
715543-231 or 715543-241