Advance Adapters 303041 - Manual

ADVANCE ADAPTERS INC. P/N: 303041
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-11-12
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 4 723131 5/16” – 24 HEX JAM NUT
2. 2 723133 5/16” – 24 x 3.0” ALL THREAD
3. 4 723134 5/16” – 18 x 1 ¼” H.H.C.S.
4. 4 723141 5/16” – 18 NYLOC HEX NUT
5. 2 723150 5/16” -24 X 6.0 “ ALL THREAD
6. 4 302203 FEMALE HEIM ROD END 5/16” – 24
7. 4 303126 BUSHING-ATLAS HEIM KIT
ATLAS HEIM JOINT RETRO FIT KIT
USED WITH 3” – 8 ¾” TUBE
Recommended when using Atlas shifter part numbers: 303000L, 303001R, 303002U, 303005L, 303006L, 303007L,
303011L, 344000, 344002, 344003, 344004, 344006, & 344007
Note: This is a universal kit and you may be required to trim part # 723133 or part # 723150 to get the exact length you need.
Assembly instuctions:
1. Put your Atlas in neutral.
2. Remove the four existing E clips, shifter buttons, igus bushings, two pieces of all thread and discard.
3. Remove the two existing brass rod ends from Atlas shift rails. Install the two new 303126 bushings using a vice or press and
re-install on the shift rails.
4. Remove the two existing shifter handles and install the new 303126 bushings using a vice or press and re-install shifter handles.
5. Assemble part # 302203 female heim end and either part # 723133 or part # 723150 using part # 723131 hex jam nuts. Do not tighten
this assembly at this point.
6. Install the assembled heim using four of part # 723134 H.H.C.S and four of part # 723141 hex nyloc nuts. The four 713134 H.H.C.S
need to be installed as shown below. Adjust heims so shift handles are parallel to shift tower.
7. Once adjustments are made you can now tighten the assembly.