Advance Adapters 50-9920 - Manual (Page 2)

SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.
ADVANCE ADAPTERS INC. P/N: 50-9920
P.O. Box 247, 4320 Aerotech Center Way New Item: (4/95)
Paso Robles, CA 93447 PAGE 2 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-05-05
STOCK JEEP TRANSMISSION
TO BRONCO DANA 20
Chrysler used an oil weep hole on the stock adapter housing. This weep hole was located in one of two locations: on
the adapter surface where the transfer case mates to the adapter or on the bottom center of the casting near the
crossmember foot. These weep holes were designed for the purpose of informing you when the seal in the tailhousing
would fail. The adapter kit spud shaft does not always contact the seal in the Jeep tailhousings. To prevent oil leaking
problems when the spud shaft does not contact the seal surface, we recommend plugging the weep hole using RTV Blue
silicone (if on the adapter housing face), or RTV Blue silicone and a sheet metal screw (when located near the crossmember
foot).