Advance Adapters 50-9807 User Manual
Kit consists of
KIT CONSISTS OF:
No.
Qty
Part No.
Description
ADVANCE ADAPTERS INC.
P/N: 50-9807
P.O. Box 247, 4320 Aerotech Center Way
New Item: (08/94)
Paso Robles, CA 93447
PAGE 1 OF 3
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
04-20-01
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
1.
1
51-9807
CASTING (3.500" Long)
2.
1
52-0203
DANA 300 INPUT SPUD SHAFT W/35T INTERNAL
3.
1
716308
NEW BEARING FOR DANA 300 BRG. RETAINER
4.
1
716457
LOCK COLLAR (Stafford No. 24SS)
5.
1
716515
GASKET
6.
1
716517
GASKET
7.
1
716749
NATIONAL SEAL (#471870)
(INSTALL IN DANA 300 RETAINER)
8.
1
723701
3/8"-16 HEX NUT
9.
14
723704
3/8" LOCK WASHER PLT.
10.
1
723711
STUD BOLT 3/8"-16 x 2"
11.
12
723723
H.H.C.S. 3/8"-16 x 1-1/2"
12.
1
723740
S.H.C.S. 3/8"-16 x 1-1/2"
13.
1
JP001
JEEP INSTRUCTION MANUAL
GM TRUCK 2WD 4SP MODEL SM465 35 SPLINE
JEEP DANA 300 T/C (Short Design)
PLEASE NOTE THE FOLLOWING:
The new transmission support area can be used with your original transmission support with only minor modifications.
Adapter bar No. 716017 could be used to adapt your original mount to the bottom of the new adapter.
Note: P/N
716021 crossmember mount should not be used with this adapter.
This adapter kit has an overall assembled length of 15-1/2". This length will be very compatible when replacing the T4,
T5 or SR4 transmissions. If using this transmission with the Jeep 6 cylinder, you will need to use Advance Adapters
bellhousing P/N 712571. This adapter could be used with V8 conversions and will require driveshaft modifications.
Adapter Kit No. 50-9802 uses the same transmission, but the adapter is 3-1/2" longer and will provide a better V8 engine
location - leaving the transfer case in its original location.