Advance Adapters 50-9102 - Manual (Page 3)

GM 700R-4 AUTOMATIC TO JEEP NEW
PROCESS TRANSFER CASE (23-SPLINES)
ADVANCE ADAPTERS INC. P/N: 50-9102
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711091-23
Paso Robles, CA 93447 PAGE 3 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-10-01
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
NOTES:
1. Before assembling the new transmission shaft into your 700R-4, you must verify the spline size of the new shaft and
the input gear of the new process transfer case. The shaft is available in either 21 or 23 spline tooth count.
2. Be sure that the adapter shaft and T/C input gear do not bottom out prior to the adapter meeting flush with the
transmission. Some models may require the output shaft to be shortened.
3. The adapter has provisions for a new seal NAT #456057, the outside diameter is 3.75" and the inside diameter is 1.937".
The seal must be installed with the open side towards the transmission.